Official monitoring feed
Search published CPSC, EU Safety Gate and NHTSA notices. Each result includes the official source, publication date, hazard and next action.
Filtered feed
The toy contains small parts (key ring with carabiner, nose, pearl halves) that may easily detach. A small child may put them in the mouth and choke. The product does not comply with the requirements of the Toy Safety Directive nor with European standard EN 71-1.
The product has an excessive concentration of perfluorohexanoic acid-related compounds (PFHxA) (measured values up to >100 mg/kg). PFHxA-related compounds are highly persistent substances that are difficult to remove from the environment and can accumulate over time, posing a risk to human health and the environment. The product does not comply with the REACH Regulation.
The seat belt may not be correctly attached to the vehicle body. As a result, the seat belt may not provide adequate restraint in the event of an accident, increasing the risk of injury. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The toy has small parts (leather medallions) which can easily become detached. A small child could put them in their mouth and choke. The product does not comply with the requirements of the Toy Safety Directive nor with European standard EN 71-1.
The welding is not sufficiently strong. The frame can therefore break apart due to the weakness at the centre of the bicycle frame. This could cause the rider to fall, which could lead to injuries. The product does not comply with the requirements of the Machinery Directive.
The LED light installed in the steps at the entrance door may overheat during use and catch fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The toy's battery compartment opens easily without tools, making the batteries inside accessible. A small child may put them in their mouth, the battery may release electrolyte that can be ingested and damage the child's digestive system. The product does not comply with the requirements of the Toy Safety Directive nor with European standard EN 62115.
The actual protection factor of the sunscreen is lower than declared (measured values lower than SPF 2). Consequently, the user will be under-protected against UV radiation increasing the risk of sunburns or skin cancer. The product does not comply with the Cosmetic Products Regulation.
The actual protection factor of the sunscreen is lower than declared (measured values as low as SPF 0). Consequently, the user will be under-protected against UV radiation increasing the risk of sunburns or skin cancer. The product does not comply with the Cosmetic Products Regulation.
The front main wiring harness may come into contact with a metal earthing stud because, following a design harmonisation change, PHEV/BEV vehicles were not fitted with the protective cap used on the MHEV version. Over time, vehicle vibrations could damage the harness insulation, allowing the wires to touch the earthing stud and cause a short circuit. This may lead to a loss of electrical functions and overheating of the wires, increasing the risk of a thermal incident or fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The toy's battery compartment opens easily without tools, making the batteries inside accessible. A small child could put them in the mouth, the battery may release electrolyte that can be ingested and damage the child's digestive system. The product does not comply with the requirements of the Toy Safety Directive nor with European standard EN 62115.
The front main wiring harness may come into contact with a metal earthing stud because, following a design harmonisation change, PHEV/BEV vehicles were not fitted with the protective cap used on the MHEV version. Over time, vehicle vibrations could damage the harness insulation, allowing the wires to touch the earthing stud and cause a short circuit. This may lead to a loss of electrical functions and overheating of the wires, increasing the risk of a thermal incident or fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The actual protection factor of the sunscreen is lower than declared (measured values lower than SPF 2). Consequently, the user will be under-protected against UV radiation increasing the risk of sunburns or skin cancer. Moreover, the product contains the preservatives. methylchloroisothiazolinone (MCI) and methylisothiazolinone (MI), which are prohibited in leave-on products. These substances cause severe skin burns and eye damage, and may cause an allergic skin reaction. Additionally, the product contains formaldehyde, which is prohibited in cosmetics. Formaldehyde is a skin sensitiser and can trigger allergic reactions and may cause cancer. The product does not comply with the Cosmetic Products Regulation.
There is a defect in the wire gate riveting on these carabiners. This assembly fault could cause the gate to break or detach, posing a risk of carabiner failure in the event of a fall, leading to injuries. This product does not comply with Personal Protective Equipment (PPE) Regulation.
The toy has small parts (the ball and the bean shapes) that can easily detach. Small children may put them in the mouth and choke. The product does not comply with the requirements of the Toy Safety Directive.
An electrical short circuit can increase the risk of a fire.
The recalled baby toy sets contain a pull string teething toy that violates the mandatory standard for toys because the silicone strings are smaller and longer than permitted. The silicone strings can reach the back of children’s throat and become lodged, posing a risk of respiratory distress and deadly choking hazard.
The recalled dressers are unstable if they are not anchored to the wall, posing tip-over and entrapment hazards that can result in risk of serious injuries or death to children. The dressers violate the mandatory safety standard as required by the STURDY Act.
The recalled pressure washers lack an integral ground-fault circuit-interrupter (GFCI) and an adequate-length power cord, posing serious risks of injury or death from shock and electrocution hazards.
The drawstrings in the recalled clothing can get caught on objects and cause death or serious injury to children due to an entrapment hazard.
The recalled pressure washers lack an integral ground-fault circuit-interrupter (GFCI) and an adequate-length power cord, posing a risk of serious injury or death from shock and electrocution hazards.
The light bars can overheat or produce flames, posing a risk of serious injury from a fire hazard.
The recalled walkers violate the mandatory standard for infant walkers because they can fit through a standard doorway and fail to stop at the edge of a step, posing a deadly fall hazard.
When the amplifiers are used with aftermarket metal base tubes, the bare metal can become electrified, posing a risk of serious injury or death from electrocution.