Official monitoring feed
Search published CPSC, EU Safety Gate and NHTSA notices. Each result includes the official source, publication date, hazard and next action.
Filtered feed
The filter transmittance is below the minimum usable level, the view may appear completely dark. Users may then remove or lift the glasses to locate the sun, exposing their eyes directly to solar radiation and creating a risk of damage to sight. The product does not comply with the Personal Protective Equipment (PPE) Regulation nor with the European standards EN 12312-2 and EN 18526-2.
The solders in the product have an excessive concentration of cadmium and lead. (measured values up to 0.51% and 93% by weight, respectively).Lead and cadmium pose a risk to the environment. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
The solders in the product have an excessive concentration of cadmium and lead. (measured values up to 0.27% and 83% by weight, respectively).Lead and cadmium pose a risk to the environment. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
The protective earth conductor is not connected and the cross-section of the cable is too small. This results in a risk of electric shock and an increased risk of heat build-up and fire. The product does not comply with the requirements of the Low Voltage Directive.
The appliance can be used with the lid open, allowing direct contact with the grinding blade while it is in motion. This could cause serious cuts to the user.In addition, the product is fitted with a two-pin flat Europlug without earthing which does not provide adequate protection against electric shock. The stainless steel grinding container may become live, the user could touch it and receive an electric shock. The product does not comply with the requirements of the Low Voltage Directive nor with the European standards EN 60335-1 and 60335-2.
The solders in the product have an excessive concentration of lead. (measured value: 34% by weight). Lead poses a risk to the environment. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
The rate of nickel release is too high (measured value up to 1.5 µg/cm2/week). Nickel is a strong sensitiser and causes allergic reactions if present in articles that come into direct and prolonged contact with the skin. The product does not comply with the REACH Regulation.
The rate of nickel release is too high (measured value up to 0.59 µg/cm2/week). Nickel is a strong sensitiser and causes allergic reactions if present in articles that come into direct and prolonged contact with the skin. The product does not comply with the REACH Regulation.
The solder in the product has an excessive concentration of lead (measured value: up to 0.52% by weight).Lead poses a risk to the environment. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
The plastic material of the product has an excessive concentration of bis(2-ethylhexyl) phthalate (DEHP) (measured values: 24% by weight). This phthalate may harm the health by causing possible damage to the reproductive system. The product does not comply with the REACH Regulation.
The kink protection of the charging cable has an excessive concentration of cadmium, lead and bis(2-ethylhexyl) phthalate (DEHP) (measured values up to 0.0122%, 37% and 7.9% by weight, respectively). Lead and cadmium pose a risk to the environment. DEHP may pose a risk to human health and the environment. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
The product has small parts that can easily detach (keychain ring and orange "fruit" on top of the capybara's head). Small children may put them in the mouth and choke. The product does not comply with the requirements of the Toy Safety Directive nor with the European standard EN 71-1.
In case the outer pane of the panoramic roof window breaks, the remaining inner pane may detach from the vehicle while in motion. This creates a hazard for other road users and increases the risk of an accident or injury. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
Improperly secured screws may cause the access panels to open while the vehicle is in motion. This could create a hazard for vehicle occupants and other road users, increasing the risk of injury. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The filter transmittance is below the minimum usable level, the view may appear completely dark. Users may then remove or lift the glasses to locate the sun, exposing their eyes directly to solar radiation and creating a risk of damage to sight. The product does not comply with the Personal Protective Equipment Regulation nor with the European standard EN 12312-2 and EN 18526-2.
Small parts of the dumpling can easily release. A small child may put them in the mouth and choke. The product does not comply with the requirements of the Toy Safety Directive nor with the European standard EN 71-1.
Small parts of the dumpling can easily release. A small child may put them in the mouth and choke. The product does not comply with the requirements of the Toy Safety Directive nor with the European standard EN 71-1.
The solders and the plastic USB part in the product have an excessive concentration of lead (measured value: up to 23% and 0.27% by weight, respectively). Lead poses a risk to the environment. Moreover, the plastic USB material of the product has an excessive concentration of bis(2-ethylhexyl) phthalate (DEHP) and dibutyl phthalate (DBP) (measured values: 13% and 0.17% by weight, respectively). These phthalates may harm the health by causing possible damage to the reproductive system. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
Small parts of the dumpling can easily release. A small child may put them in the mouth and choke. The product does not comply with the requirements of the Toy Safety Directive nor with the European standard EN 71-1.
The solders in the product have an excessive concentration of lead (measured value up to 48% by weight). Lead poses a risk to the environment. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
The solder in the product has an excessive concentration of lead (measured value up to 0.43% by weight).Lead poses a risk to the environment. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
The solders and the cable insulation in the product have an excessive concentration of lead (measured value up to 23% by weight). Moreover, the cable insultation of the product has an excessive concentration of bis(2-ethylhexyl) phthalate (DEHP) (measured value up to 6.3% by weight). Lead poses a risk to the environment. DEHP may harm the health by causing possible damage to the reproductive system. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).
The toy has an excessive concentration of dibutyl phthalate (DBP), benzyl butyl phthalate (BBP), bis(2-ethylhexyl) phthalate (DEHP), diisobutyl phthalate (DIBP), di-‘isononyl’ phthalate (DINP) and di-‘isodecyl’ phthalate (DIDP) (measured values: 0.03 %, 0.01 %, 8.3 %, 0.01 %, 0.02% and 0.02% by weight, respectively). These phthalates may harm the health of children, causing possibly damage to the reproductive system. The product does not comply with the requirements of the Toy Safety Directive nor with the REACH Regulation.
The solders in the product have an excessive concentration of lead (measured value up to 0.43 % by weight). Lead poses a risk to the environment. The product does not comply with the requirements of the Directive on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS 2 Directive).